Gemini-2 and Gemini-1 Telescope Mount Controllers
Website and Tutorials by Thomas Hilton
only search
There is a new Question and Answer Wiki section where you can ask searchable questions.

Quick Start Tutorial - click on green button to Navigate
You have to enter your coordinates into the latitude and longitude, don't worry about the offset, we will do that on the next screen. If you select the different locations, you can see the sign change on the display. Notice that the Longitude is Negative in the USA and Positive in Europe

Touch in the Longitude box. When you do the Longitude entry screen will appear.
Do what is indicated in that screen. After that you will be brought back to this screen.

Touch in the Latitude box, You will be taken to a screen similar to the one you just filled out. After filling out that screen you will be brought back here again.

Hit the Next button to be taken to then NEXT screen.

Note: the Hemisphere is selected totally by the sign of the Latitude in the Gemini-2. Positive for Northern Hemisphere and negative for Southern Hemisphere. It was the same in the Gemini-1 also. No switches to change at all.

The Query GPS button will have the Gemini-2 try and get the GPS coordinates from a GPS unit hooked to Serial Port 1.
See GPS receiver link below.
The speed of this ports defaults to 4800 baud for GPS use. It's speed is set in the Web interface under Serial Tab.

Note: If you are using a GPS receiver. to get the time, then the offset does not matter. The Gemini-2 only uses UTC time for all it's calculations, and a GPS returns UTC time only.  You can disregard the time screen when using a GPS receiver.  You  can have the hand controller show the correct local time by setting the TimeZone Correctly (include DST if active in your time zone.)  If you set TimeZone to zero then the time shown will be UTC.
Bottom page
This site is not for profit and sells nothing and asks for no money for any help it provides.  This site is here to help fellow Gemini-2 and Gemini-1 owners. This Web Site is not associated with Losmandy-Hollywood General Machining Inc. or any of their employees and never has been. There is no guarantee that all the information is correct, but strives to provide the best information possible. The use of any information is at your own risk.  The webmaster is an unpaid beta tester, and tries to work with other beta testers, and René the writer of the firmware.  If you would like to help keep this web site going send your gift to Your gift will be used to defray the cost of keeping this web site up, unless you specify otherwise.
Hit counter by Hit Counter by Digits
Your Privacy Policy
No Information is collected by this site.  Cookies are set in your browser, but only for visited
links to change color.
Your use of any information on this site is at your own risk.

Gemini-2 and Gemini is a registered trade names of Hollywood General Machining Inc.